Search results

Appreciate the assist!😁

Looks like I’ll be going the NWP route…now I just need to figure out the bearings, seals, o-rings, gaskets, etc.!!😆😂

Just a phone…😆

Sure would be nice if HLSupply would create a clickable tab on this forum so I don’t have to open another google page😉. Hey, they could even insert hyper-links if someone posts a specific part #…just a thought😉. Thanks for the great gathering place, I can actually navigate around on this one!!😁

Though I may end up going the NWP route if I can’t source a good used oem crank…🤷🏼‍♂️

Hey guys, looking for a good OEM crankshaft for my 2001 385xp as the existing one gave up the ghost. Let me know if you’ve got one for sale. Thanks much!😁

Appreciate it, but trying to stick with OEM for the critical components on this saw😁

Looks like new crank + bearings & seals time😆😂. Anyone have a line on a good used crank for this thing?

Found the culprit…😳

I believe I isolated at least 1 issue with the saw….😆😂

Is Tygon the best fuel line to run for both the fuel & pulse lines? If so, what OD line to get a good fit/seal?

Not yet, no vacuum tester yet…seems saws need tools I don’t seem to have 😆😂

Even though there’s lots of fuel going into the carb, it still feels/seems like it’s running lean, so I’m wondering if it’s pulling air in from somewhere…since it won’t idle, it’s hard to use WD-40 or brake cleaner to check around the base gasket & intake, so I’ll just pull ‘em…need to pull them...

Not really….I’m going to pull the cylinder tomorrow to see if it blew out part of the base gasket, and check the intake boot for cracks/rips…I have another one on the way already as I plan on replacing most of the parts on the saw due to it’s age.

It doesn’t matter if it’s at 1/2 turn or 3 full turns…something else seems to be amiss🤔

Saw running with the H screw @ 1 1/4 out & the L @ 2 turns out…tried it @ 1 1/2, 1 3/4, 2, 2 1/4, 2 1/2 & finally 3 full turns out…just won’t hang @ idle…

Yeah…buyer beware for sure!! But hey, I learned a lot more about small carbs today for sure!!😆😂

Well, I received the “rebuilt” carb I bought from a guy for $50 in one of the FB saw groups….put it on, hooked everything up, and….nada!! Nada drop of fuel into the carb, so I pulled it out, tore it apart, and…the diaphragm was as crispy as fall leaves, the metering needle was worn out, the...

But I do have the carb off at the moment🤷🏼‍♂️

I held it in the air by the starter handle, and the saw bop, bop, bopped right to the floor…