Latest activity
-
Bob Hedgecutter replied to the thread Need help adjusting throttle cable on Makita EA7900p.The sheath is likely fallen out of the holder within the rear handle assembly, -
BBlaze44 posted the thread Need help adjusting throttle cable on Makita EA7900p in Chainsaw Questions.Hi everyone, I recently put a new carb on my 79cc Makita/Dolmar and the throttle cable is too tight. It holds the throttle open about...
-
Bob Hedgecutter replied to the thread Won't start.Then my first guess would be a massive air leak that took the cylinder out originally has not been corrected. Or, straight gas took out...
-
Nnijoma replied to the thread Won't start.Ryobi ry3714. Replaced. Ignition coil, carb, fuel & air filters, fuel lines, gaskets, spark plug, cylinder, stop switch, primer pump...
-
Bob Hedgecutter replied to the thread Won't start.First off- make and model? Second off- explain complete rebuild?
-
NComplete rebuild of 2 stroke for chain saw good spark good compression I believe good fuel...changed fuel filter and lines and put in...
-
Jjim112725 replied to the thread Husqvarna Clutch Lubrication.Thank you again.
-
Bob Hedgecutter replied to the thread Husqvarna Clutch Lubrication.If there is no drilling- then yes, only time/chance to lubricate said bearing is when the clutch is off for oil pump checks and or...
-
Jjim112725 replied to the thread Husqvarna Clutch Lubrication.Bob, I really appreciate your quick reply. Prior to submitting the post, I thoroughly examined the area you referenced. If you stick a...
-
-
Bob Hedgecutter replied to the thread Husqvarna Clutch Lubrication.See that hole in the middle of the crank shaft? Oil or grease goes in there and goes out through a cross drilling at about the middle of...
-
JTrying to figure out the proper way to lubricate the clutch drum needle bearing on a Husqvarna 440e ii which was purchased in 2021. From...
-
-
SScott kunz replied to the thread 038 mag2.
-
SScott kunz replied to the thread 038 mag2.
-
SScott kunz replied to the thread 038 mag2.
