No doubt. Nothing wrong with that, education is always good. Though sometimes frustratingYeah…buyer beware for sure!! But hey, I learned a lot more about small carbs today for sure!!
No doubt. Nothing wrong with that, education is always good. Though sometimes frustratingYeah…buyer beware for sure!! But hey, I learned a lot more about small carbs today for sure!!
Can't see your video but go the other way with the screw, out further is just more fuel.Saw running with the H screw @ 1 1/4 out & the L @ 2 turns out…tried it @ 1 1/2, 1 3/4, 2, 2 1/4, 2 1/2 & finally 3 full turns out…just won’t hang @ idle…
Is it smoking an excessive amount?It doesn’t matter if it’s at 1/2 turn or 3 full turns…something else seems to be amiss
Not yet, no vacuum tester yet…seems saws need tools I don’t seem to haveHave you done a vacuum test? Often when a saw won’t tune it’s an air leak in my experience.
A preasure and vacuum tester saves a lot of Time and money.Not yet, no vacuum tester yet…seems saws need tools I don’t seem to have
Real tygon is decent line, echo fuel and impulse line is the best IMO. 3x5 and 3x6 work for most thingsIs Tygon the best fuel line to run for both the fuel & pulse lines? If so, what OD line to get a good fit/seal?
Though I may end up going the NWP route if I can’t source a good used oem crank…
Looks like I’ll be going the NWP route…now I just need to figure out the bearings, seals, o-rings, gaskets, etc.!!not oem But a good crankshaftNew West crankshaft for Husqvarna 385 390 390XP New Jonsered 2186 2188 | eBay
Fits Husqvarna chainsaw models 385 390 390XP and Jonsered chainsaw models 2186 2188. Really nice quality part made by New West Products with 1 year warranty.www.ebay.com