desol
New member
Hi. New to the Forum. Just wanted to post about my TimbrePro CS6150 needing a new fuel line assembly. If yours ever breaks off in the gas tank...you'll have to remove the entire fuel tank assembly to get to the grommet that goes in the top of the tank. Also on the top of the fuel tank is the tank vent.You'll want to put a new gas vent in while you have everything apart. Also to mention, I took apart the muffler assembly. There is no flame arrestor screen in this saw. The muffler vents in the inside port were clogged with oil...so to clean, I just used a propane torch and heated up the inside vent slots until everything was red hot. Let it cool down and blew it out with a compressor. You have to burn out the oil with the torch in the sealed muffler assembly to keep it clean. Couple photos of the job attached. Engine, Carb, New fuel line assembly hooked to purge bulb and Gas tank vent (white plastic thing). This is a link to the fuel line assembly I used. https://www.amazon.ca/dp/B0DXDV5TNC?ref=ppx_yo2ov_dt_b_fed_asin_title
Attachments
Last edited: