Poulan Pro (Husqvarna) Saw starts but will not run

Indyguy

New member
Local time
2:13 PM
Joined
Nov 14, 2026
Reaction score
1
Location
Indianapolis, Indiana, USA
I can start the saw normally (prime, pull out the choke, pull the cord, move to the middle "start" position, and pull cord again). The engine revs up and runs very strong in start position: Strong enough to cut through a tree if I could control the throttle.
As soon as you pull the throttle and it goes into "run" mode, the saw putters and dies within about 5 seconds. If you try to open the throttle or feather it, it dies instantly.

I thought maybe this was caused by using fuel from the gas station that contains ethanol (Which I was ignorant about before), so I took the carburetor off, disassembled it on both sides, cleaned out everything, reassembled the saw.... same problem.
Next, I ordered a Zama rebuild kit, replaced all the seals, the diaphragms, the screen, and all the hardware (spring, valve, pin, ETC), and reassembled the carburetor. I also replaced all the fuel lines and the primer bulb. Got everything put back together, refilled the saw with Husqvarna branded fuel, and..... exactly the same problem.

At this point, I decided I better consult someone who actually knows what they are doing. Maybe I need to adjust the L and H screws on the carb? But how could these be out of adjustment when I don't even own the right tool to turn them, and no one but myself has ever worked on the saw?
I'm hoping that someone can tell me what I am missing?
 
Maybe your low-speed mixture is likely set too lean. Here's the tool.
https://opepartsmart.com/product/unnamed-pj91021/

If L screw makes no difference, try cleaning the carb or replace it.

The following may help other folks with this problem, not you. You may be more experienced.
Did you begin with fresh, properly mixed fuel?

That seems like one that is starved of fuel, running too lean. When you squeeze the trigger to enter "run" mode, the choke opens completely and lets in a rush of air. Because the engine cannot pull enough fuel to match that extra air, it starves and dies.

Check the fuel lines inside and outside the gas tank for cracks, brittleness, or a detached fuel filter, all of which would bring in extra air.
Check for clogged filter restricting fuel flow.
Check for clogged tank vent.
Remove the muffler cover and check if the small wire mesh screen is clogged with carbon buildup.
 
Sounds like you've covered just about everything on the fuel and carburetor side of things. One thing I'd check is the fuel tank vent and make sure it's not plugged. Also worth checking the impulse line and the intake boot for air leaks. A carburetor can be completely rebuilt and still have trouble if it's not getting the proper fuel supply or crankcase pressure.

I wouldn't start adjusting the L and H screws just yet. I'd try to narrow down the problem first. Could also be worth checking the spark arrestor screen in the muffler to make sure it's not plugged.

Hopefully someone familiar with that particular saw can point you in the right direction
 
Back
Top