Found an interesting wee saw for sale- kind of locally. Never seen one in the flesh before, but knew they existed- I guess some home gardeners have some gnarly Rose bushes?
MS200
- Thread starter Bob Hedgecutter
- Start date
Cooperize
New member
Hi anyone know if there is a sprocket spline clutch drums for the ms200t or any that will fit ? Whant to be able to run 1/4 353 3/8 chains I’m stuck with 3/8 spur drives at moment
Not to the best of my knowledge- there is a 8T 1/4" spur drive available (may not be available in the States?) part number- 1129 640 2051.
I have heard of slices off spurs being silver soldered to spline drives to work the oil pump- but that sounds like a difficult option.
Well, just like buying a rare car that you have not seen many of- you buy one and another shows up for half the price- so I bought that one as well. 
The intentions with the second was to take the good bits from it, mash them up with some 200T parts I have kicking about and make a top handle for sale.
Probably not a rabbit warren I would advise anyone to attempt unless you have complete examples of both saws- sure, they share some bit, but there are some quirky differences as well!
However, if you ever had the inkling of running an 7T spur on a 200T the MS200 rear handle has an 7T spur and oil pump worm to suit- least the two I have here do. That is just one of the quirky differences!
The intentions with the second was to take the good bits from it, mash them up with some 200T parts I have kicking about and make a top handle for sale.
Probably not a rabbit warren I would advise anyone to attempt unless you have complete examples of both saws- sure, they share some bit, but there are some quirky differences as well!
However, if you ever had the inkling of running an 7T spur on a 200T the MS200 rear handle has an 7T spur and oil pump worm to suit- least the two I have here do. That is just one of the quirky differences!
Last edited: