Wild Bill
New member
The only thing I have not replaced are the two wires from the kill switch, they look almost new, but I think I will make new ones and see what happens. They make up a bundle of two from the coils ground wire and the coils kill wire, then into a shrink wrap and then thru a grommet and into the base of the saw and then out of the wrap just before the kill switch itself. They might possibly be shorted together. The coil is new, I have 2 new and one old, the spark plug is new and works, tested it on another unit, The flywheel was removed, cleaned and reinstalled, all grounds were clean and shiny. What could possible keep the coil from firing the spark plug.