Recent content by Iroczu

Same saw in frozen white oak

If anyone's in 025/ms250 stuff. It was my first clam I've dug into personally with a gridner. Nothing crazy just wanted a good bush beating slap it on my side by side saw

Ms260 cylinder roughed in

Ported 026, poted 038 mag, husky 61, 162, ms250 in these pictures

This 026, ms260 topend starting to port this week and a couple hatchet projects(this was a test fitting and seeing how the end result will look). Bench is a disaster at the moment, just waiting on my 162se cylinder to come back and that'll be going on it soon

The 162se is closed port yes, I'll be waiting a bit, sent the cylinder out to get the base cut when the fellow has time. I have been back into the 026 raised the exhaust groove from 97 to 94 and for some reason it didn't change a thing with rpm, did some piston cleaning and window opening which...

I like the fact you didn't have to hack up the factory filter cover👊

That'll be a interesting thing, I was looking at doing a 044 carb but... issue was seeing how others done their swaps and rather not mangle a filter cover to keep stock look. Had some other ideas I may pursue at a later date but pretty happy with a stock carb so far, was reading other folk doing...

The area in white, if you take the roundness out but don't go too thin it'll also help flow a bit, what did you all do to your uppers? Maybe tomorrow if weather is decent I have some testing and videos to take running the 18 inch with 325 again and compare stock vs ported 026 head to head. I...

I may have one I would have to check, have 2 parts 10'10s kicking around but condition is unknown of both as I got them as parts. Kensi left? Thought he was moderator??

Ya I've tried a couple different things to lowers like enlarging width, and funneling the air flow and directing flow to in theory help with sweeping the piston dome with more pressure, kept the transfer same width and going towards and nearly to the base. Just have to be careful unless you...

Is your squish with sealant or a base gasket? See how it runs, I'm using stock domed piston and a tad tighter squish, but the lower transfers I ran mine almost to the base of the cylinder and found bigger gains by opening them up a bit longer in mine. This ported 026 is getting shipped down...

I wouldn't ever run the 026 with a 32, video was for curiosity purposes, which I in think it would pull that chain, oiler won't keep up to a bar that size, av mounts maxed out it is definitely a if you want to destroy your saw go for it lol have some interchangeability things to try out now...

Not my saw, a fellow saw was working on. Stihl ms171 minus dirt in 1 pictue he melted the case around the brake band,melted the worm gear for the oil pump, stretched out the clutch springs, and melted the bearing cage for the clutch bearing. He couldn't remember how long it was idling for with...

Here's the dumb tests of tests 😂