Bob Hedgecutter's latest activity
-
Bob Hedgecutter replied to the thread Jonsereds 910E. -
-
Bob Hedgecutter replied to the thread Nut Job - Husqvarna 440.Okay, if your chain is that kapoodled that tightening the clutch cover caused it to bind- I would be looking pretty seriously at the...
-
Bob Hedgecutter replied to the thread Nut Job - Husqvarna 440.So anyhow- have you recently replaced the chain- the bar- or both?
-
Bob Hedgecutter replied to the thread Question About A New Chain....In my way of thinking, pretty normal and once run a bit, you might find it settles into a more conforming shape. Put your old chain back...
-
Bob Hedgecutter replied to the thread Nut Job - Husqvarna 440.Have you recently replaced the chain- the bar- or both? If all ducks are in a row, the nut must be reasonably tight to do its job- not...
-
Bob Hedgecutter replied to the thread No start -- Flywheel magnets?.291's are a temperamental kind of saw- I would be pressure and vacuum testing as a matter of course if it is hard to start/wont start.
-
Bob Hedgecutter replied to the thread No start -- Flywheel magnets?.No, you should not. The second pair of unmarked "magnets" are counterweights- they mimic the weight of the actual magnets that cause...
-
910E I bought around 6 weeks ago, way up in our other Island- got a buddy to pick it up and send it down- arrived yesterday. Basically...
-
-
Bob Hedgecutter replied to the thread Help with 661.Best Bubba guess ( I do not do a lot of mtronic stuff), bad connections in the electrical system- especially the solenoid on the carb...
-
Bob Hedgecutter replied to the thread Jonsereds 80.Only part really missing was the one lower bolt for the front of the rear handle- fortunately these are the same as the hex head cap...
-
Have one already- but another arrived at my doorstep yesterday. They differ in slight ways, mainly around the recoil starter. Has the...
-
-
Bob Hedgecutter replied to the thread Trash picked 029 Super.One mans trash is another mans treasure. Was recently gifted a good Jonsered 2055 in the same scenario- saved at the recycling centre.
-
Sometimes it amazes me that things people just toss in the trash. I found this last night on my way home, sitting in a bright orange saw...
-
Bob Hedgecutter replied to the thread Danarm 1-71-SS.There was a version of the Frontier saw made for Dolmar that was an orangey red. Photos would determine for sure. The Frontier saws had...
-
Bob Hedgecutter replied to the thread Danarm 1-71-SS.Frontier made the small top handle saws for Danarm out of Canada- but they were usually blue cased. They made those for just about...
