Latest activity
-
SI have a Stihl MS291 that will not start. It has a weak spark; certainly weak compared to my MS461. Tested the wiring and kill switch...
-
910E I bought around 6 weeks ago, way up in our other Island- got a buddy to pick it up and send it down- arrived yesterday. Basically... -
-
Only part really missing was the one lower bolt for the front of the rear handle- fortunately these are the same as the hex head cap... -
Have one already- but another arrived at my doorstep yesterday. They differ in slight ways, mainly around the recoil starter. Has the...
-
Bob Hedgecutter replied to the thread Help with 661.Best Bubba guess ( I do not do a lot of mtronic stuff), bad connections in the electrical system- especially the solenoid on the carb...
-
JHey guys, question about my 661. If I let it sit over night then try to start it sometimes starts for a few seconds then dies but if I...
-
Bob Hedgecutter replied to the thread Jonsereds 80.Only part really missing was the one lower bolt for the front of the rear handle- fortunately these are the same as the hex head cap...
-
Have one already- but another arrived at my doorstep yesterday. They differ in slight ways, mainly around the recoil starter. Has the...
-
-
Bob Hedgecutter replied to the thread Trash picked 029 Super.One mans trash is another mans treasure. Was recently gifted a good Jonsered 2055 in the same scenario- saved at the recycling centre.
-
Sometimes it amazes me that things people just toss in the trash. I found this last night on my way home, sitting in a bright orange saw...
-
OSometimes it amazes me that things people just toss in the trash. I found this last night on my way home, sitting in a bright orange saw...
-
-
Ooilsmoke replied to the thread Danarm 1-71-SS.I'd have to really go digging to find it up there but both fill caps were on an angle on the front of the saw, ahead of the loop handle...
-
Bob Hedgecutter replied to the thread Danarm 1-71-SS.There was a version of the Frontier saw made for Dolmar that was an orangey red. Photos would determine for sure. The Frontier saws had...
-
Ooilsmoke replied to the thread Danarm 1-71-SS.I'd have to go digging upstairs in the garage to find it, but from what I remember it was all die cast aluminum. I think the trigger was...
-
Bob Hedgecutter replied to the thread Danarm 1-71-SS.Frontier made the small top handle saws for Danarm out of Canada- but they were usually blue cased. They made those for just about...
