Search results

A recent video of a 562xp thru Wny ash. Saw has rowdy pipe and the cylinder was lightly flowed / blueprinted. A velocity stack and more aggressive flow work will give much greater gains … As you listen to the saw cut notice I do not favor the high rpm like some other builders do - I just take...

I appreciate that , atm I’m very busy making piped exhausts for customers. Now … a velocity stack , flow work and one of these rowdy pipes really make a saw pull hard in the wood ! Here is what I’m talking about …

eBay may have them available, there is another guy , red hair saws or something like that who sells 3D printed versions iirc. The price of 6061 aluminum round stock has gotten so expensive that it’s just not worth my time to machine one-offs and keep the price to under $30/unit shipped! I just...

Why yes … yes I can 😂 - the 362c featured in this absolute shellacking of a stock 562xp is the same one that Mastermind (of ope forum fame) himself wanted to purchase from me - I guess it is his favorite model ? … I respectfully declined the offer 😉🥩🍳💪🪓🤣🪵🦍😺….

Yah, it looks like you’re about 6000mi + from California so ya won’t be gettin nothing for $20 … and Bob’s your uncle

Uhh … unless you live on a deserted island with no post office / usps I’m going to respectfully disagree. You can visit the farmertec website and “faux” buy the item and see what it costs to your door if so inclined. Tec o mec makes the same product but it’s a bit more expensive… best regards !

Wanna bet ?

An excellent upgrade to the 2100 series is a muffler off a STIHL 090. You can get one to your door for less than $20 and offer a noticeable improvement over the stock can imho

I’ve had good luck with meteor so far

Looks like Jonny nitro is baaaaaack !

Crap shoot at best ! 361 is a worthy saw to rebuild - I’d spend the coin and go oem if possible , alotta of those Chinesium cylinders just do not make good power

Someone say 2100 ? no bananas or sausages in THIS build … steak 🥩 and eggs 🍳 ONLY 😀

About 20miles In a v10 F250

Looking for a 1990 262xp with non decomp kolbenschmidt cylinder and the hd-87 carb

Update: Ironhorse has returned the saw to it’s rightful owner. I’ve never seen so much drama 🎭 over a fricken chainsaw. Then again , apparently when clicks and $$$ are involved all bets are off. It appears the original video poster is on record saying he was going undercover to “expose...

The 262xp is a nice lil saw especially when built properly. Even if you could install a 268 cylinder on that bottom end most likely you wood be going backwards performance wise. However …. A 266/268 chassis upgraded to a 272xp top end , high flow filter , carb and exhaust work makes for a...

The 555 manual lists the coil air gap as .3mm + - .1mm as acceptable. I use my business card which is .012 or very close to .3mm. Never had an issue with any saw at this setting (.012) mtronic/auto or conventional. If the guy replaced the original carb with another and no spark ⚡️ then I would...