Menessis's latest activity

  • M
    Menessis replied to the thread Husqvarna 136.
    Hey Bob thanks for all the help and support! I cleaned the needle and the seat again and reassembled the saw. And what do you know it...
  • M
    Menessis replied to the thread Husqvarna 136.
    You can see the middle extends past the outer arms quite a bit.
    • W.png
  • M
    Menessis replied to the thread Husqvarna 136.
    OH....I forgot. While apart I did have a look at the piston. Not a mark on it. Also You can see the middle extends past the outer...
    • W.png
  • M
    Menessis replied to the thread Husqvarna 136.
    OK Bob.....it's picture time. What's wrong with this picture? :)
    • IMG_3707.jpeg
    • IMG_3708.jpeg
  • M
    Menessis replied to the thread Husqvarna 136.
    OK. Thanks again Bob. Stay tuned I will go give that a try right now.
  • M
    Menessis replied to the thread Husqvarna 136.
    I had to take a break.....I was getting to annoyed LOL I'm not sure of what you mean here "straight nipple of nipple with a groove in...
  • M
    Menessis replied to the thread Husqvarna 136.
    OK Cool....I was hoping you would tell me a method of adjusting the needle. You agree that's what's going on here now. When this all...
    • Screenshot 2024-04-24 at 17-20-04 Husqvarna 136 Chainsaw OEM Replacement Parts From eReplaceme...png
  • M
    Menessis replied to the thread Husqvarna 136.
    From bad to worse. Got an impulse kit today. I noticed fuel in the cylinder. Enough to dump out and wipe up the puddle on the floor...
  • M
    Menessis replied to the thread Husqvarna 136.
    Ohhhhhh....I see. Didn't know that little tid bit. Thanks Bob.
  • M
    Menessis replied to the thread Husqvarna 136.
    I'm wondering if the vent is plugged. If the vent is open there shouldn't be any pressure build up due to temp change??
  • M
    Menessis replied to the thread Husqvarna 136.
    So what do make of the positive pressure in the fuel tank.
  • M
    Menessis replied to the thread Husqvarna 136.
    Ya I didn't change the gasket. I see another common problem is a poor joint in the impulse pipe. That is what makes it pump fuel.
  • M
    Menessis replied to the thread Husqvarna 136.
    Ya I did the carb kit already... there was a lot of debris on the screen in the carb. The bubbles are weird I think. Also I don't...
  • M
    Menessis posted the thread Husqvarna 136 in Chainsaws.
    My Old Husqvarna 136 didn't get much use in the past few years. I need that saw running this summer though. But it has other ideas...
Show older items
Top