Bob Hedgecutter's latest activity
-
Couple of boxes were sitting at my front door when I got home last night- both reasonably hard to find here in NZ. A nice example of a... -
-
Bob Hedgecutter replied to the thread Stihl 011 AVT bar oil leak.Can you clean it up and determine exactly where the oil is leaking from? 009, 011, 012 all leak oil and at the age they are now- are...
-
Bob Hedgecutter replied to the thread Husq 359 kill switch.No. The ring terminal goes to the mounting bolt of the coil itself. Do you have an air compressor? Clean the area the coil sits in-...
-
-
Bob Hedgecutter replied to the thread Homelite xl 2 carburetor.If you have refreshed and squared away the carb to the best of your abilities- maybe the carb is not your issue. First thing I would be...
-
Bob Hedgecutter replied to the thread Husqvarna Customer Service.Yep well where I come from- a shrug of the shoulders does not cut it. Personally I would not have left the shop without proof of...
-
Bob Hedgecutter replied to the thread Husqvarna Customer Service.In my mind, there should be a paper trail following the refusal and you as the owner are entitled to see that. My guess is- you took the...
-
Bob Hedgecutter replied to the thread Stihl 046 dies when throttle released.First thoughts- too rich on the H circuit. If all other ducks are in a row tuning wise, I would make small adjustments to the H by say...
-
Bob Hedgecutter replied to the thread Stihl 020AV Super chainsaw.020AV was 38mm bore 020AV Super was 40mm 020AVT was a top handle saw- ie: arborist or tree climbers saw 020AVP was the "professional"...
-
Bob Hedgecutter replied to the thread Stihl 020AV Super chainsaw.Don't bother with the Stihl site- just go to open internet- it will be there somewhere. Stihl pretty much drop anything that was not...
-
Bob Hedgecutter replied to the thread Stihl 020AV Super chainsaw.Few other adjustments? There are only 3 screws for tuning- the High the Low and the idle speed screw. I have all the manuals for the...
-
Bob Hedgecutter replied to the thread Stihl 020AV Super chainsaw.Cold start- apply full choke, pull starter until first "pop" as saw fires- move master control to half choke/fast idle, start saw- once...
-
Bob Hedgecutter replied to the thread Husqvarna 445 xTorq does not start.Were the carb and sparkplug OEM replacement parts- ie: NGK spark plug- not TORCH or some other crapola name? Pressure and vacuum test...
-
Bob Hedgecutter replied to the thread Stihl 020AV Super chainsaw.Idles for 20 seconds, starts, idles and goes up to full throttle for 20 seconds? H&L should be around 1 turn out from lightly seated-...
-
Bob Hedgecutter replied to the thread Husqvarna 445 xTorq does not start.Spark, correct fuel air mix entering the combustion area, compression and correct timing is all it takes for a chainsaw to run. Photos...
-
Picked up a couple of cheap old saws the other day, photo of them as they hit the ground out the back of the truck in the pre dawn hours...
-
