Recent content by BigSachsDolmar

Ever play with the old jred 450? I got 2 complete and one parts saw.. parts saw is a 510sp and has 2mm bigger bore which could be fun...

I know that some companies had shown some interest in taking the reigns of such a legendary brand.... it could make poulan good again....hahah

I agree but they won't buy them... stihl thinks their saws throw gold instead of chips.... yes stihl has top notch saws but they also make *poop* tons of *poop* saws... disposable saws

For 34cc its impressive nicely done

Its got some top end no doubt. But how is the tq? Would it rip thru that if it was oak or elm or some hardwood that isn't punky like that pine.. I'm guessing it would do much better than I imagine

Let's hope they get bought... maybe stihl should buy them then they would have some good quality stuff to work with hahah

You can make almost anything fit with a lil creativity and fabrication

Yes itll fit but the hardware will be a bit different for the supports.. a ms461 muffler will also fit

Bmep.... bitchin max extra power?

I'll let u know the oem numbers when I get the saw... I paid for it 3 weeks ago tomorrow... so it better come soon...wouldn't more tq be lower on the exhaust number near 100? Just finished this 205 with a 225 p and c i ported

Do u know the numbers b4 and after?

FYI the billet one on mine is a 461 muffler

Put a oem ported 64cc jug on for now debating oe79cc or am84cc i got a 2511t coming i got for 60$ might have to ask u about timing numbers u hit

I've never swapped just yank that cat out the 6421 and mod the muffler to your liking I run Bosch number 7

I learned from a very good saw builder that using a stone on the uppers works extremely well. I just widen to desired size than angle the dremel a little bit to bring the port up to where I want it... on the upper transfers thats not much, just a little bit