The stock bore of a poulan 3400 is 1.812 inch or 46.03.mm
Stroke is 1.319 inch or 33.5 mm
Green Ripper has a 56 mm bore 2.205 inch
Stroke is 39.69 mm or 1.562 inch
Hope this helps you find out what you are looking for.
It sure does make it easier to get what you are dreaming about down the road and into the trees.
The 395 cylinder and piston was the set that was the easiest to use. Same piston pin diameter and length to fit the poulan 5200 crank that was almost to easy to fit in the case. I need to do a...
This is my little poulan 3400 that is a nice saw, I did a little work on it and it grew up a little to 98cc. It is called Green Ripper. Thought some of you might be interested in a sleeper saw
Not sure what size I have. The first one was too small and the one that I have now is off the press at work that has a leak in the seal and they put a new one on and I asked for the old one. It was running to fast and so I had to gear it down and it seems to work fine.
I need to make some...
Anyone know how to check the 5200 type coil and module. The manual tells you to use a check light. Is the light just a flash light with 2 wires hooked up to it. I wish I had one to copy.
I made mine with the stuff that I had, I can only compare with mine. I can load the saw and get a pressure at what rpm. It is more of a check how they run and brake in runs.
Just a little bit of background on me. I'm a retired machinist that helped design and make the machines that make tator tots and other fast food potato products. I have several hobbies besides the saws and that is model steam engines, not the train but the steam motors of the past.
I have...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.