Search results

I'm sure you do, new name same stuff. My hand is a little sore and I can't start a saw and it sucks but I will be OK in a few weeks.

See above

The stock bore of a poulan 3400 is 1.812 inch or 46.03.mm Stroke is 1.319 inch or 33.5 mm Green Ripper has a 56 mm bore 2.205 inch Stroke is 39.69 mm or 1.562 inch Hope this helps you find out what you are looking for.

I made a louver die for the 3400 poulan and turn them in to 4000 style

It sure does make it easier to get what you are dreaming about down the road and into the trees. The 395 cylinder and piston was the set that was the easiest to use. Same piston pin diameter and length to fit the poulan 5200 crank that was almost to easy to fit in the case. I need to do a...

This is my little poulan 3400 that is a nice saw, I did a little work on it and it grew up a little to 98cc. It is called Green Ripper. Thought some of you might be interested in a sleeper saw

A few a bit later

Some pictures of the first go around

Not sure what size I have. The first one was too small and the one that I have now is off the press at work that has a leak in the seal and they put a new one on and I asked for the old one. It was running to fast and so I had to gear it down and it seems to work fine. I need to make some...

If I can help you i sure will with pictures or anything else

Where do you get the cutterless chain. I ground mine off because I have never seen cutterless before.

Anyone know how to check the 5200 type coil and module. The manual tells you to use a check light. Is the light just a flash light with 2 wires hooked up to it. I wish I had one to copy.

I made mine with the stuff that I had, I can only compare with mine. I can load the saw and get a pressure at what rpm. It is more of a check how they run and brake in runs.

Just a little bit of background on me. I'm a retired machinist that helped design and make the machines that make tator tots and other fast food potato products. I have several hobbies besides the saws and that is model steam engines, not the train but the steam motors of the past. I have...

I'm the guy that has the poulan 3400 that has the husky 272 cylinder that you offered to port.

No that isn't me, I tried to get him to respond to a question I asked if he had any saws for sale but I never got a answer.

Just a few that are making some noise

Most of mine but not all of them

The thread size is 12-24 for the 5200 muffler bolts for those that are interested. You can go with a heil coil, brand name, or you can go up in size to 1/4-20. I like to keep them stock size but the thread kits are in the 35.00 dollar range. Good luck with what you choose and if I can help I will.