Stihl MS180c...where does this wire plug in?
- Thread starter riverzx
- Start date
Into the master control lever- under the spring metal clip that carries grounding from the cylinder to that wire and grounds out the coil to stop the saw.
As viewed from the rear of the saw, slightly right of the choke rod entry to the main control lever there is a channel the brass end of the held wire pushes into.
As viewed from the rear of the saw, slightly right of the choke rod entry to the main control lever there is a channel the brass end of the held wire pushes into.
Thank you for the reply. I guess I was looking for a metal female end on something for that to plug into rather than a plastic channel!
So you got it sorted and you are all good?
Yes, thanks.