Concrete saw won't start. Any suggestions?


New member
1. Gotta have spark
2. Gotta have compression
3. It has to be getting fuel
4. It needs to get air.

1. Pull plug, rest on jug head, pull cord, watch for spark.
2. Best to have a compression gauge, borrow if need be, 100psi + best, will run down to around 80 psi or so
3. After pulling ovet about 8 times, pull plug, is it wet ?
If not...
My expirience with fuel is to rebuild the carb, clean all orfices with carb cleaner, or bare minimum wd 40 type aerosol to blow crap out.
4. 90% of the time air is not an issue however, check the filter, clean/replace .

Good luck